Search This Blog

Wednesday 21 October 2015

My Reprap Prusa i3 Kit [ second of a multipart blog] - The Build!

This past weekend, I finally had the time to start building my Reprap Prusa i3 3D Printer,  which I ordered a few weeks ago from  Shenzhen Sunhokey Electronics Co., Ltd. on Aliexpress.com

 

 

 

 

 

 

  

 

 

The kit came with a DVD which included about a dozen videos of the step-by-step assembly process.  There is no speech in the videos, just some background music, and periodic overlay of the hardware required to assemble each step.

 

The videos run at a fairly leisurely pace, but yes... I did have to pause them many times to keep up. 

 

Here's a sample video to show you what 

the process looks like.

 The build started fairly smoothly, with the X-axis motor block and opposite belt tensioner slider assemblies. (Yeah, I'm too lazy to look up the official names of these two components)



 

 

 

My Assistant and fellow builder - Camden, found himself getting rather tired, early into the build! But, like a trooper, he put in a good couple hours.  Thank you Camden.




Next up, was the actual hotend carriage assembly.  I'll have to admit, it was very exciting to see these pieces built first.  Good job Shenzhen Sunhokey Electronics Co., Ltd.!  

At first, I wasnt sure how I would feel about the transparent acrylic frame and parts, but as the build progressed, I grew rather fond of it.

 





 

 

 

Next came Z-Axis Motor brackets, end stops, and then the frame and rails for the Y-Axis heated bed


I wrapped up for the weekend at this point.  Two days of "duration", and about 6 hours of "effort".   

 

 

The next three articles over the upcoming week will be: 

1) wiring all of the motors, switches, heaters, etc to the control board and firing it up.   

2) calibrating and troubleshooting (probably not in that order!)  

3) finally running a first print. 

 

Cheers.

 

 

No comments:

Post a Comment